Configure The Qlogic Adapter In Windows Server; Network Connections Window - Qlogic 3000 Series User Manual

Configure the QLogic Adapter in Windows Server

To enable the connections to the QLogic adapter:
1. Open the Network Connections window in the Control Panel, or directly from
the desktop if the icon exists
Note that if an IP address has not been assigned, the QLogic adapter entry
says Limited or no connectivity.
If there is a red
do the following:
See
To check the status of the connection, right-click the adapter icon in the
Network Connections window and select Properties. The Local Area
Connection Properties dialog box opens.
NE0154601-00 A
5–Windows Server 2003 and 2008 Driver Installation and Configuration
Figure 5-16. Network Connections Window
X next to QLogic adapter icon, the link is down. In this case,
Verify that the card is seated properly in the PCI slot.
Make sure that the network cable is connected properly at both ends.
Make sure that the cable is good.
Assign an IP address to the interface if you have not already.
Verify that the SFP+ module is installed correctly (QLE3142).
Section 9 for more information.
Configure the QLogic Adapter in Windows Server
(Figure 5-16).
5-21