Updating The Flash On Multiple Standalone Adapters - Qlogic 3000 Series User Manual

Here is an example of a Windows Server nxflash --info output for local
area connection 0:
C:\Users\Administrator\Desktop\4.0.223\utils>nxflash.exe -i
"Local Area Connection 0" --info
NETXEN Port is Port 0
Verifying flash...Done.
Board Type
Board Chip Rev
Serial Id
Efuse ID
Firmware version (on Flash) : 4.0.228
Active Firmware version
Firmware in
Driver version
BIOS version
MAC Addr 0
MAC Addr 1
MAC Addr 2
MAC Addr 3
Subsystem ID
PHY Type
PXE Status

Updating the Flash on Multiple Standalone Adapters

The Flash can be updated on multiple QLogic adapters on the same host using
one of the following procedures.
To perform updates from the same directory tree, type the following
commands sequentially after the Flash update has completed. In these
commands, n represents two different port numbers, for example, "Local
Area Connection 4" and "Local Area Connection 5" (the
quotation marks are required).
NE0154601-00 A
nxflash.exe -i "Local Area Connection n" --all (first
QLogic adapter)
nxflash.exe -i "Local Area Connection n" --all (second
QLogic adapter)
QLogic Adapter Flash Update — Windows Server
: 0x24 (Quad Gig LP)
: B1
: QG87BK0092
: 0x4e36343633340f08
: 4.0.229
: CUT-THRU mode
: 4.0.229
: 2.0.0
: 00:0E:1E:00:79:DC
: 00:0E:1E:00:79:DD
: 00:0E:1E:00:79:DE
: 00:0E:1E:00:79:DF
: 0x01244040
: UNKNOWN PHY
: Disabled
C–Flash Update
C-7