Qle3044 Bracket Removal And Replacement; Qle3044 Bracket Replacement - Qlogic 3000 Series User Manual

QLE3044 Bracket Removal and Replacement

Depending on the type of system, installation of the QLE3044 requires either a
long bracket or a short bracket. QLogic provides both of these brackets with the
product. The brackets for the QLE3044 are different from previous brackets in that
they slide over the top of the four RJ45 Ethernet jacks.
To remove and replace the bracket:
1. Remove the screw at the top of the QLE3044 that holds the bracket in place.
2. The bracket covers the top of the RJ45 Ethernet jacks. Slide the bracket
upward towards the top of the QLE3044 until it clears all of the Ethernet
jacks.
3. To replace with a different bracket, reverse the process, sliding the new
bracket over the Ethernet jacks. Then fasten in place with the screw.
The removal and replacement process is illustrated in
respectively.
NE0154601-00 A
1. Remove screw using
a Phillips screwdriver.
2. Slide the bracket upward
until it clears the four RJ45
Ethernet jacks.
Figure 4-3. QLE3044 Bracket Removal
1. Slide the bracket down
over the four RJ45
Ethernet jacks.
Figure 4-4. QLE3044 Bracket Replacement
Figure 4-3
Bracket
Bracket
2. Fasten the screw using
a Phillips screwdriver.
RJ45
RJ45
RJ45
RJ45
4–Hardware Installation
QLE3044 Installation
and Figure 4-4,
4-3