Qle3142 Installation - Qlogic 3000 Series User Manual

4–Hardware Installation

QLE3142 Installation

QLE3142 Installation
To install the QLE3142:
1. Verify that the system is powered down and unplug the power cord.
2. Remove the system cover.
3. Locate an empty x8 PCIe slot.
4. Remove the SFP+ optical modules from the QLE3142 if they are already
inserted (see
5. Insert the QLE3142 into the x8 PCIe slot. Apply uniform pressure on top of
the QLE3142 until it is firmly seated in the bus connector.
6. Connect the SFP+ module or copper direct attach twinax cable. Listen for an
audible clicking sound when the optical module is inserted into the housing
(see
7. Secure the bracket to the chassis and replace the cover.
8. Connect the appropriate cables to the QLE3142.
9. Plug in the power cord and power up the system.
NOTE:
The optical module must be seated correctly in the housing to ensure proper
operation.
4-4
Figure 4-5).
Figure 4-5).
NE0154601-00 A