Qlogic 3000 Series User Manual page 90

A–Diagnostic Utility Commands
Command
--noCRegs
--noFLASH
--noIRQS
--noIntLB
--noHw
--noLinkSt
--noLED
--ExtLB
--help
--version
--Cmdif
A-2
Table A-1. Diagnostic Utility Commands (Continued)
This command disables control register testing (use with -D or
-nR
-a).
This command disables Flash testing (use with -D or -a).
-nF
This command disables interrupt testing (use with -D or -a).
-nl
This command disables internal loopback testing (use with -D or
-nL
-a).
This command disables hardware testing (use with -D or -a).
-nH
This command disables link status testing (use with -D or -a).
-nS
This command disables LED status testing (use with -D or -a).
-nl
This command performs an external full-duplex loopback test.
-E
This command prints the help message.
-h
This command displays version information.
-v
This command performs an interface status test.
-C
NOTE: This command is valid only in Linux.
Description
NE0154601-00 A