Whirlpool SF387LEGN1 Use & Care Manual page 28

2, Holdovendoorso thatthetopedgeofeach
hingehanger i s horizontal. Insert h ingehangers
intothefrontframehingeslots.
3, Tilt top of door toward range. Slide hinge hangers
down onto front frame support pins.
NOTE: Make sure the hinge hangers are fully seated
and engaged on the support pins.
4, Insert the door stop clip with the angular surface
at the top of the frame hinge slot, then push in
the bottom of the clip until flanges are flush with
the front frame.
5, Open the door completely and remove the door
removal pins. Save door removal pins for future
use.
6, Close the door.
Door stop r_ II Range
clip /_ I I!
I111 Hinge
Door removal
_1111
)r _ ; .................................... hanger
pin hole _ _'(, /
........................... Support pins
Door removal
pin hole .............
Front frame
hinge slot
II Angular
surface of
door stop
clip
"'i'"!,i!! i]!(i1,,[! ....
The oven light will come on when you open the
oven door.
• Push the oven light pad. F_
U
1.
Unplug range or disconnect power.
2, Remove the glass bulb cover in the back of
the oven by turning it
counterclockwise.
4, Replace the light bulb cover by turning it
clockwise.
5, Plug in range or reconnect power.
3,Remove the light bulb from its socket. Replace NOTE: The oven light will not work during the
the bulb with a 40-watt appliance bulb. Self-Cleaning cycle.
28