Whirlpool SF387LEGN1 Use & Care Manual page 10

Electronic
display
Oven selector
pads
(pp. 13, 15, 1
16, 17, 22)
SELF-CLEANING OVEN
LOOKII IIL'o"T1 /".. I I O ''l
/ II TIMERII /
........... oFF L U LV/LVJ
Temperature ...... Clock Minute Oven Hour Minute
pad pad timer set light pads pads
(pp. 13, 15, (p. 11) and off pad (p. 11, (p. 11,
16, 17, 22) pads (p. 28) 21) 21)
(pp. 11, 12)
Off/cancel
pad
Start/enter (pp. 12,
14, 16, 22)
pad
(pp. 10, 11,
12, 14, 16,
22)
• When you first plug in the range, everything on
the display will light up for 1 to 2 seconds, then
a time of day and "PF" will appear on the
temperature display. Press the off/cancel pad to
clear "PF" from the display. If, after you set the
clock (see the "Setting the clock" section), "PF"
again appears on the display, your electricity
was off for a while. Reset the clock, if needed.
• When you are not using the oven, the display will
show the time of day.
• When you are using the oven or minute timer, the
display will show times, temperature settings,
and what command pads have been pressed.
• When showing the time of day, the display will
show the hour and minutes.
• When you are using the minute timer, the display
will show minutes and seconds in the following
sequence:
- For settings from 1-59 minutes, the display will
count down each second.
- For settings 1 hour or over, the display will
count down hours and minutes.
The control lock lets you shut down the control
panel command pads. The control lock comes in
handy when you want to prevent others from using
the oven.
NOTES:
• You can only use the control lock when the oven
is not in use or the control has not been set.
• Set the control lock when cleaning the control
panel to prevent yourself from accidentally turning
on the oven.
• The control lock will stay on even after a power
failure.
To lock the control panel:
Press and hold START/ENTER for 5 seconds.
You will hear a single tone and "Loc" and
"LOCK'D" will appear on the temperature
display.
To unlock the control panel:
Press and hold START/ENTER for 5 seconds.
You will hear 3 tones followed by a single
tone. "Loc" and "LOCK'D" will disappear
from the temperature display.
10