Nac Policy Tasks; Enabling Or Disabling A Nac Policy; Changing The Nac Policy Selection Order; Figure 123: Nac Policy Selection Order Buttons - Extreme Networks Sentriant AG Software User's Manual

NAC Policy Tasks

This section describes the following NAC policy tasks:
"Enabling or Disabling a NAC Policy" on page 205
●
"Changing the NAC Policy Selection Order" on page 205
●
"Selecting the Default NAC Policy" on page 206
●
"Creating a New NAC Policy" on page 206
●
"Editing a NAC Policy" on page 214
●
"Copying a NAC Policy" on page 214
●
"Deleting a NAC Policy" on page 215
●
"Moving a NAC Policy Between NAC Policy Groups" on page 215
●

Enabling or Disabling a NAC Policy

Select which NAC polices are enabled or disabled.
To enable or disable a NAC policy:
Home window>>NAC policies
Click on the enable or disable link. As shown in
indicated by a red strike-through icon.

Changing the NAC Policy Selection Order

To change the NAC policy selection order:
Home window>>NAC policies
Click on the up or down arrows next to the NAC policies to move change the selection order of the
policies within the NAC policy group as shown in the following figure:

Figure 123: NAC Policy Selection Order Buttons

When an endpoint attempts a network connection, it is compared to the endpoints of each NAC policy,
in the order designated by the selection order, until it matches a policy. The matching policy is used to
Sentriant AG Software Users Guide, Version 5.3
Figure 120 on page 202, a disabled NAC policy is
NAC Policies
205