Operating System Setup - EUROCOM Notebook V09.1.00BETA User Manual

Operating System Setup

If you are installing new system software, or are re-configuring your computer for a different system, make sure you
configure the appropriate OS setting in the BIOS before installing a new operating system.
1. Start-up the computer and press <F2> to enter the BIOS.
2. Go to the Advanced menu, select "Installed O/S" and make sure the appropriate operating system is selected.
3. Go to the Exit menu and select "Exit Saving Changes" (or press F10 and select "Yes" then press Enter) and
press Enter to exit the BIOS and reboot the computer.
Main
Advanced Chipset Control
Installed O/S:
SATA Mode Selection:
Reset Configuration Data:
Boot-time Diagnostic Screen:
Legacy OS Boot:
Power On Boot Beep
Battery Low Alarm Beep:
FAN Control:
F1
Esc
Phoenix SecureCore(tm) Setup Utility
Advanced A A dvanced Security
DFOROM(Robson) Support:
Help Select Item
Exit Select Menu
Figure 1 - 2 - BIOS (Operating System Selection)
Boot Exit
Item Specific Help
[Vista]
Select options for
[AHCI]
Advanced Chipset
[Enabled]
features.
[No]
[Disabled]
[Enabled]
[Disabled]
[Disabled]
[Automatic]
-/+ Change Values
Enter Select Sub-Menu
Quick Start Guide
F9 Setup Defaults
F10 Save and Exit
Operating System Setup 1 - 7
1