Intel Turbo Memory Module; Intel Turbo Memory & Matrix Storage Setup And Driver Installation - EUROCOM Notebook Manual

Intel Turbo Memory Module

If you have included an Intel Turbo Memory (Robson) NAND flash memory card
module in your purchase option, then you will need to enable the option in the BIOS
(see
"Advanced Menu" on page 5 - 8
erating system software (do not enable this option in Windows XP or on a Windows
Vista operating system that has been installed without the option enabled).
Intel Turbo Memory Technology (also known as Robson flash memory) is an Intel
technology that reduces the time it takes for a computer to boot up, to load applica-
tions, and to write data to the hard drive. Intel Turbo Memory Technology is sup-
ported in Windows Vista only (it also supports Windows Vista features such as
ReadyBoost, ReadyDrive, and Superfetch).
Intel Turbo Memory & Matrix Storage Setup and Driver Installation
1. Start-up your computer and press F2 to enter the BIOS.
2. Go to the Advanced menu, select "Installed O/S" and make sure "Vista" is
the selected option (see
3. Go to the "SATA Mode Selection" item and make sure "AHCI" is selected.
4. Go to the "DFOROM (Robson) Support" item and make sure "Enabled" is
selected.
5. Go to the Boot menu (see
) BEFORE installing the Windows Vista op-
"Advanced Menu" on page 5 -
"Boot Menu" on page 5 -
8).
13).

Intel Turbo Memory Module 7 - 33

Modules
e-SATA Port Hot-
Swapping Support
Note that the Intel Ma-
trix Storage driver is
required to support e-
SATA port hot-swap-
ping even if you have
not included an Intel
Turbo Memory module
in your purchase config-
uration.
Follow the instructions
provided here in order to
install the driver.
7