Ata Mode Setup - EUROCOM Notebook User Manual

ATA Mode Setup

1. Prepare a formatted blank 3.5" 1.44MB floppy diskette, and an external USB floppy disk drive.
2. Create an ATA Driver Diskette by using an operable computer to copy the Drivers\RAID\ATA folder
from the Device Drivers & Utilities + User's Manual CD-ROM (Navigate/Browse.. to
D:Drivers\RAID\ATA) to the blank floppy diskette.
3. Connect the external USB floppy disk drive to the notebook computer.
4. Startup your computer and press <F2> to enter the BIOS (see
5. Set the RAID/ATA Mode Select to ATA Mode (see
page 5 - 10).
Main Advanced Advanced
Setting items on this menu to incorrect
values may cause your system to malfunction.
System Information
I/O Device Configuration
Reset Configuration Data:
Hyper Threading Technology:
Power On Beep
Card Reader :
RAID/ATA Mode Select
F1 Help
Esc Exit
PhoenixBIOS Setup Utility
Security Power
Setup Warning
[No]
[Enabled]
[Disabled]
[Enabled]
[ATA Mode]
Select Item -/+ Change Values
Select Menu Enter Select Sub-Menu
"The Setup Program" on page 5 -
"RAID/ATA Mode Select: (Advanced Menu)" on
Boot Exit
Item Specific Help
F9 Setup Defaults
F10 Save and Exit
ATA Mode Configuration 4 - 3
Drivers & Utilities
4).
Figure 4 - 1
BIOS Advanced
Menu
4