EUROCOM W860CU Service Manual page 37

Disassembly
Processor Installation Procedure
Figure 10
Processor
1. Insert the CPU
Installation
turn the release latch
2. Remove the sticker
a. Insert the CPU. 3. Insert the heat sink
b. Turn the release latch to-
4. Tighten the CPU heat sink screws in the order
wards the lock symbol.
10d).
c. Remove the sticker from
5. Replace the CPU fan, component bay cover and tighten the screws
the heat sink and insert
the heat sink.
a.
d. Tighten the screws.
b.

A. CPU
D. Heat Sink
• 4 Screws
2 - 14 Removing and Installing the Processor
, pay careful attention to the pin alignment, it will fit only one way (DO NOT FORCE IT!), and
A
towards the lock symbol
B
(Figure 10c) from the heat sink.
C
as indicated in Figure 10c.
D
1
c.
A
C
B
(Figure 10b).
, &
, (the order as indicated on the label and
2 3 4
(page 2 - 12).
d.
4
D
2
Note:
Tighten the screws
in the order 1, 2, 3, 4
as indicated on the
label.
Figure
1
3