Table of Contents
Advertisement
Setup & Operation
Monitoring
In all Operating Modes, digital signal monitoring is available at the analog outputs. Moni-
tor function setup choices are shown below. For more information see the Menu Descrip-
tions in the Reference section, page 40.
Monitor Function
Source
Level
Phase
MONHD16 (HDCD 16-bit
Amplitude Decoding)
Gain Scaling
Input HDCD Code Detect
*Follow Meter
**-11.9 to +24 dBu at 88.2, 96, 176.4 and 192 kHz
Note: It is recommended that the Monitor Output Level be set close to +18 dBu to provide
the best combination of digital resolution and analog output stage performance.
Power Switch
CAUTION: Follow instructions in the Installation section before switching power on.
The Power Switch toggles between power on and power off. When the Model Two is off,
pressing the Power Switch will turn the Processor and Power Supply units on. At power up
all system settings remain as they were before power off. When the Model Two is on,
pressing the Power Switch will call up the Power Off Menu:
POWER OFF MENU
PWR_OFF
Pressing the button labeled (PWR_OFF) will display the following prompt, "Power down
HDCD unit? Press ENTER to confirm, or any other key to cancel". Press ENTER to turn off
power, or press the button labeled (CANCEL), or any other button, to cancel.
P A C I F I C
Rev. C - January 2002
Choices
Folwmtr*, Out 1, Out 2, Dig In
Stereo, Ch 1, Ch 2, -78 to +24 dBu** Levels
Normal, Invert
Auto, On, Off
On, Off
24-BIT, 20-BIT, 16-BIT
CANCEL
M I C R O S O N I C S
®
Model Two HDCD
User's Manual
Menu
Monitor Source
Monitor Setup
Mon.Set./Lvls/S.Op.
Mon. Setup/S.Op.
Mon. Input HDCD
Code Detect
I N C .
®
16
Locations
Hide quick links:
Advertisement
Table of Contents
