Model Two Power Supply Description - Pacific Microsonics HDCD Model Two User Manual

Installation

Model Two Power Supply Description

The Power Supply is contained in a 14" wide X 2.5" high X 12.25" long enclosure and
connects to the Processor using a 6 foot multiconductor DC power cable. To prevent ground
loops from occurring between the AC power ground and audio signal ground, there is no
ground connection between the Power Supply and the Processor. The Power Supply con-
nects to a 100V to 240V, 50/60 Hz AC power source using a standard IEC grounded AC
power cord. The rear panel connections on the Power Supply are as shown below:
1 DC Output Connector
(28-pin female)
2 AC Line Voltage Select
3 AC Power Fuse
4 AC Input Connector
(IEC 3-pin male)
P A C I F I C
Rev. C - January 2002
Model Two HDCD
AC Line Voltage
Select
Connects from the Power Supply to the DC Input on the
Processor using the supplied DC power cable.
Line voltage selection: 100V, 120V, 220V, 240V, AC, 50/60
Hz. (USA units are preset to 120V) AC input voltage must
be within a + 5% to - 10% range of the selected voltage.
Requires 3A (100V-120V) or 1.5A (220V-240V) 3AG fast
blow fuse.
Connects to AC power outlet using grounded IEC AC
power cord.
M I C R O S O N I C S
®
11
®
User's Manual
I N C .