Yamaha RX-V571 Owner's Manual page 77

Setting the bi-amp connections
Switch the bi-amp connections of the front speakers on or off. Refer to "Connecting front
speakers compatible with bi-amp connection" (p.16) for details.
Settings
ON Turns bi-amp connections on.
OFF (Default) Turns bi-amp connections off.
Changing TV format
Change the color encoding format of TV monitor to PAL or NTSC, to match the format
used by the TV connected to the unit.
Settings
NTSC, PAL
• The default setting differs depending on your country or region.
Removing HDMI video output upscaling limits
This unit automatically detects the resolutions supported by the TV connected to this
unit with an HDMI cable, and restricts the resolution selected in the "Resolution" (p.74)
of the "Setup" menu (monitor check function). When a resolution that the TV does not
support needs to be selected, this menu will remove the limitation from the settings
selected in "Resolution."
Settings
Enables the monitor check function. (Video output signals of a resolution
YES (Default) not supported by the TV will not be transmitted.)
Disables the monitor check function. (Video output signals of any
SKIP
resolution will be transmitted.)
• If no picture is output from the TV and this unit goes out of control after "MON.CHK" is set to "SKIP," set this
item back to "YES."
Changing FM/AM frequency steps
(Asia and General models only)
You can select one of the following FM/AM frequency steps:
Settings
You can adjust the AM frequency by steps of lOkHz and FM by steps of
AM10/FM100
100kHz,
You can adjust the AM frequency by steps of 9kHz and FM by steps of
AM9/FM50
50kHz.
• The default setting differs depending on your country or region.
• For details on setting FM/AM frequency steps, refer to "Changing FM/AM tuner frequency steps (Asia and
General models only)" (p.41).
Initializing various settings for the unit
Initialize various settings stored in the unit depending on the selected item from the
following.
Settings
DSP PARAM Initializes all parameters for the sound programs.
ALL Resets the unit to default factory settings.
CANCEL (Default) Does not initialize.
en
77