Yamaha RX-V571 Owner's Manual page 64

Setup menu list
Front
Center
Surround
Configuration Surround Back
Speaker Subwoofer
Distance
Level
Equalizer
Test Tone
Lipsync
Dynamic Range
Sound
Max Volume
Initial Volume
CINEMA DSP 3D
DSP
Program
Input Rename
Auto Power Down
Function Dimmer
Short Message
Memory Guard
TV Audio Input
ARC
HDMI Control
Standby Sync
HDMI SCENE
Audio Output
Standby Through
Processing
Language
Phase
Bass Cross Over
Extra Bass
Selects the size of the front speakers. 65
Selects the size of the center speaker and whether or not to use the speaker. 65
Selects the size of the surround speakers and whether or not to use the speakers. 65
Selects the size of the surround back speakers and whether or not to use the speakers. 65
Selects the phase of the subwoofer signals. 66
Sets the lower limit of the low-frequency component produced from speakers set to "Small." 66
Selects the speaker to produce the front channel low-frequency components. 66
Separately adjusts the distance between each speaker and the listening position respectively. 66
Separately adjusts the volume of each speaker. 66
Selects an equalizer type. 67
Turns the test tone generator on or off. 67
Adjusts the delay between audio and video output. 68
Selects the dynamic range adjustment method for the audio bit stream (Dolby Digital and DTS) signal playback. 68
Specify the maximum volume level that can be adjusted by VOLUME on the remote control. 68
Sets the initial volume for when the unit is turned on. 68
Enables/disables CINEMA DSP 3D. 69
Selects and adjusts a sound program and a decoder. 69
Changes the input source name. 71
Selects the amount of time after no operation is done that the unit enters standby. 71
Reduces the brightness of the front display. 71
Turns the short messages displayed on the TV screen on or off. 71
Prohibits setting changes to prevent careless changes being made to the settings of the "Setup" menu, YPAO, and SCENE. 72
Selects the input source that receives audio signals from a TV. 73
Turns the Audio Return Channel function (ARC) on or off. 73
Selects the interlocked operation of the unit when the TV is turned off. 73
Selects whether or not to interlock an external device connected to this unit when selecting the appropriate SCENE. 73
Specifies where audio signal is output. 73
Specifies whether or not to transmit HDMI audio/video to the TV during standby mode. 74
Adjusts resolution and aspect ratio with conversion of video signal to HDMI. 74
Selects the language used for menus and messages output from the unit and displayed on the TV screen. 75
En
64