Yamaha RX-V571 Owner's Manual page 29

Optimizing the speaker settings automatically (YPAO)
The YPAO microphone (supplied) detects the status of speaker
connections and the distance between these speakers and the
listening position, and adjusts the volume balance and the tone
settings automatically (YPAO: Yamaha Parametric room Acoustic
Optimizer).
Set the YPAO microphone at the height of your ear in
your listening position. Connect the YPAO
microphone to the YPAO MIC jack on the front panel.
The unit (front)
ENTER
• Be aware of the following when using YPAO.
- After completing the connection of a TV, speakers, and so on, start YPAO
measurement.
- The test tone is output at a high volume while measuring. Please take care that
the test tone does not frighten any small children. Also, avoid using YPAO at
night, so as to not make your neighbors troubled.
- Keep your room quiet while measuring.
- Do not connect headphones to the unit.
- YPAO can be performed by viewing the front display of the unit.
Preparation before using YPAO
2
3
Press RECEIVER (_ to turn on the unit.
Turn on the TV, and then select the input source of
the TV to the video input from the HDMI OUT jack of
the unit.
Turn on the subwoofer, and then set the volume of
the subwoofer to half. The cross-over frequency is
set to maximum if it is present.
CROSSOVER/
HIGH CUT VOLUME
YPAO microphone
Ear height
Place the YPAO microphone at ear height in
your listening position. We recommend using
a tripod to adjust the height. You can use the
tripod screws to fix the microphone in place.
The following display appears on the TV monitor and front
display.
• When a subwoofer that supports the automatic standby function (turn off
automatically during no signals input) is used, disable the function before
going to the next step.
• To cancel the measurement, disconnect the YPAO microphone before
measuring or press the cursor key (V) to select "Exit" and press ENTER.
En
29