Table of Contents
Advertisement
ADJUSTING
THE CABLE TENSION
When the resistance setting changes, the motor will
be heard. To prevent damage to the motor, do not
pull any of the cables while the resistance
setting
is changing.
If a cable is pulled, the words
RELEASE HANDLES AND READJUST RESiST-
ANCE AS DESIRED may appear in the main display
on the console.
if this message is displayed repeatedly but no cable
is being pulled, there may be too much tension on the
upper cable (A). Adjust the tension as described
below.
To decrease the tension on the upper cable (A), turn
the two 3/8" x 38mm Tension Screws (13) twice,
counterclockwise.
Select the desired resistance set-
ting. Repeat this step if necessary
CLEAMNG
THE CROSSBAR
GUIDES
Over time, dust may build up on the Crossbar Guides
(15), causing a squeaking noise as the resistance
system is used. If this occurs, wipe off the Crossbar
Guides with a damp cloth and a mild, non-abrasive
detergent. Do not use solvents.
13
A
13
21
Hide quick links:
Advertisement
Table of Contents
