Weider CrossBow Platinum WESY78730 User Manual page 13

26. Press two 19mm Round inner Caps (51) into a
Pad Tube (50). Slide the Pad Tube into the Leg
Lever (56). Slide two Large Foam Pads (52) onto
the Pad Tube.
Attach the other two Pad Tubes (50) to the Leg
Lever (56) and the Leg (5) in the same manner.
27. Attach a 90mm Pulley (40) inside of the Leg (5)
with an M10 x 85mm Button Bolt (92), two MI0
Washers (106), two 22mm Spacers (61), and an
M10 Nylon Locknut (103).
28. Wrap a High Cable (101) over a 90mm Pulley
(40). Attach the Pulley to a Pulley Housing (39)
with an MI0 x 44mm Button Bolt (93) and an M10
Nylon Locknut (103).
Repeat this step with the other High Cable
(101) and Pulley Housing (39).
29. Attach the Curl Pad (43) to the Curl Post (42) with
two M6 x 16mm Screws (41).
30. Make sure that all parts have been properly tight=
ened. The use of the remaining parts will be
explained in ADJUSTMENTS, beginning on the
following page.
Before using the resistance system, turn on
the console and change the resistance setting
as described in CONSOLE OPERATION on
page 18. Refer to TROUBLESHOOTING on
page 21 and adjust the Crossbar Cable ten-
sion as described.
26
52
27
28
29
13
5
56
0
\ 51
50 52
/
61
106
_ 92
93
4O
43 _
41