Weider CrossBow Platinum WESY78730 User Manual page 10

15. insert t heconnector ontheConsole (67)intothe
socket o nthe Upper W ireHarness (71).Thecon-
nectorshouldslideeasilyintothesocketand
snap
into place, if the connector does not slide
easily and snap into place, turn the connector over
and then insert it.
Make sure that the connector and wires appear
as shown in the inset drawing. IF THE CONNEC-
TOR iS NOT iNSERTED PROPERLY, THE CON-
SOLE MAY BE DAMAGED WHEN THE POWER
IS TURNED ON.
Push the excess wire into the Upright (2).
Attach the Console (67) to the Upright (2) with
four M4 x 70mm Screws (114).
16. Attach a Large Pulley (14) and the Pulley Plate
(68) to the Upright (2) with an M12 x 62mm
Button Bolt (81) and an M12 Nylon Locknut (119).
Do not tighten the Locknut yet.
17. Pull the upper cable (A), which is attached inside
of the Mech Frame (not shown), up between the
Upright (2) and the Pulley Plate (68).
Attach another Large Pulley (14) to the Upright (2)
and Pulley Plate (68) with an M12 x 62mm Button
Bolt (81) and an M12 Nylon Locknut (119). Make
sure that the upper cable (A) is between the
two Pulteys.
Hold the 38mm Spacer (113) inside the loop of
the upper cable (A), and between the Upright (2)
and the Pulley Plate (68). Attach the Spacer with
an M10 x 58mm Button Screw (90). Make sure
the ends of the cable do not wrap around
each other below the Spacer and the Pulleys
(14) used in steps 16 and 17 (refer to the
CABLE DIAGRAM on page 20).
Tighten the M12 Nylon Locknuts (119) used in
steps 16 and 17.
18. Attach a Small Guide Spacer (18), a Large Guide
Spacer (17), and two Crossbar Guides (15) to the
Upright (2) with an M10 x 152mm Bolt (86).
Pull the upper cable (A) up between the Crossbar
Guides (15). Press the metal cover on the cable
into the groove in the Crossbar Block (16). Attach
a Small Guide Spacer (18), the Crossbar Block,
the two Crossbar Guides (15), an M10 Thick
Washer (54), and the two Tethers (70) to the
Upright (2) with another MI0 x 152mm Bolt (86). Do
not tighten the Bolt yet.
15
16
17
18
114
81
68
14
2
119
A
./
81
68
18
86
Metal
54
18
16 Groove
7O
86
10