Weider CrossBow Platinum WESY78730 User Manual page 7

.
insert the four connectors of the lower wire har-
ness (C) into the sockets of the Upper Wire
Harness (71). The connectors should slide easi-
ly into the sockets and snap into ptace, if a con-
nector does not slide easily and snap into place,
turn the connector over and then insert it.
Make sure that the connectors and wires appear
as shown in the inset drawing. IF THE CONNEC-
TORS ARE NOT INSERTED PROPERLY, THE
CONSOLE MAY BE DAMAGED WHEN THE
POWER IS TURNED ON.
Pull the excess lower wire harness (C) out of
the Mech Frame (6) and push Btand the Upper
Wire Harness (71) into the Upright (2). insert
the Mech Frame into the Base Plate (1).
Attach the Mech Frame (6) to the Upright (2) with
a 1/2" x 25mm Screw (85) and a 1/2" Lock
Washer (12). Do not tighten the Screw yet.
Attach the Mech Frame (6) to the Base Plate (1)
with four MI0 Nylon Locknuts (103).
Tighten the 112" x 25ram Screw (85).
6. Press two Leg Outer Caps (62) onto the Leg (5).
.
Attach the Leg Bracket (109) and the Leg Lever
Bumper (55) to the Leg (5) with two M5 x 56mm
Screws (108).
Pull the Seat Knob (48) and remove the Seat
Carriage (44) from the Rail (not shown).
Attach the Seat (45) to the Seat Carriage (44)
with four M6 x 16ram Screws (41).
6 12
85
103 ,-"
/
1
103
109
\
55
62 /
5
41
41
Tag