Weider CrossBow Platinum WESY78730 User Manual page 11

19. insert the Resistance Bow (9) between the
Crossbar Guides (15), and center it on the
Crossbar Block (not shown).
Remove the paper backing from a Bracket Plate
(11) and stick it to the end of Resistance Bow (9).
Press a Pulley Bracket (10) onto the Resistance
Bow. Screw a 3/8" x 38mm Tension Screw (13)
into the Pulley Bracket a couple of turns. Make
sure the hexagonal hole in the Screw is on the
outside of the Bracket.
Attach a Tether (70) to the Pulley Bracket (10) at
the upper hole, with an M10 x 64mm Button Bolt
(80), an M10 Thick Washer (54), and an M10 Nylon
Locknut (I03).
Repeat on the other side of the Resistance
Bow (9). Then, tighten the lower M10 x 152ram
Bolt (86) used in step 18.
20. Hold a Large Pulley (14) inside the upper cable
(A). Attach the Pulley to a Pulley Bracket (10)
with an M12 x 58mm Button Bolt (87) and an M12
Nylon Locknut (119). Make sure that the cable
is routed as shown in the CABLE DIAGRAM
on page 20.
21. Hold a Large Pulley (14) inside the upper cable
(A). Attach the Pulley to the other Pulley Bracket
(10) with an M12 x 58mm Button Bolt (87) and an
M12 Nylon Locknut (119). Make sure that the
cable is routed as shown in the CABLE DIA-
GRAM on page 20.
Tighten the two 318" × 38ram Tension Screws
(13) an equal number of turns until the upper
cable (A) is tight.
22. Press two 25mm Square inner Caps (34) into the
Backrest Frame (32). Attach the Backrest Cap
(33) to the Backrest Frame with two M4 x 16mm
Screws (118).
Attach a Plastic Foot (36) to the Backrest Frame
(32) with an M4 x 16mm Screw (118).
19
2O
22
34
32
119
87
7O
119
3
10
118
118
11