Advertisement
TROUBLESHOOTING
Make sure all parts are propedytightenedeach time the weightsystem is used. Replace any worn parts immedi-
ately. The weight system can be cleaned using a damp clothand mild non-abrasivedetergent. Do not use solvents.
TIGHTENING THE CABLES
Woven cable, the type of cable used on the weight system, can stretch slightlywhen it is first used. If there is
slack in the cables before resistance is felt, the cables should be tightened. To tighten the cables, first insertthe
weight pins into the centers of the weight stacks. Slack can be removed from the cables in several ways:
See drewlng 1. To tighten the Squat Cable (73) or the Swivel
High Cable (not shown), first loosen the 1/2" Nut (118) on the
end of the Cable, away from the 1/2" Washer (1). Screw the
end of the Cable farther into the Weight Tube (43). Then,
retightenthe Nut against the Washer.
See drawing 2. To further tighten the Squat Cable (73), first
remove the 318"Nylon Locknut (87), the 318"x 2" Bolt (100),
Cable Trap (68), and 3 1/2" Pulley (78) from the indicated
bracket on the Long Base (120). Reattach the Pulley and
Cable Trap between a lower set of holes with the Bolt and
Nylon Locknut.
See drawing 3. To tighten the other five cables, first remove
the upper or lower 318"Nylon Locknut (87), 3/8" x 2" Bolt
(100), 3 1/2" Pulley (78), and Cable Trap (68) from the Pulley
Plates (63) or Small Pulley Plates (not shown). Reattach the
Pulley and the Cable Trap between a set of holes closer to
the center of the Pulley Plates with the Bolt and Locknut.
See drawing 4. To remove additionalslack, first remove the
318"Nylon Locknut(87), 3/8" x 2" Bolt(100), 3 1/2" Pulley
(78), and Cable Trap (68) from the "U"-bracket (64). Reattach
the Pulley and the Cable Trap between the higher set of
holes in the "U"-bracket with the Bolt and Nylon Locknut.
Do not overtlghten the cables. If the cables are overtlght-
ened, the top weights will be lifted off the weight stacks.
If a cable slips off the pulleys repeatedly, it may have
become twisted. Remove the cable and re-Install It. If the
cables need to be replaced, see ORDERING REPLACE-
MENT PARTS on the back cover of this manual.
100
78
25
Advertisement
