Garmin G900X Installation And Maintenance Manual page 452

C.1.2.4 Miscellaneous (if applicable)
Verify that any optional probes (e.g. P-300C Capacitive Fuel Probes, Magnetic Tach Sender, etc) have
been installed, identified, recorded on warranty registration, and configured.
C.1.2.5 Autopilot Software Verification (if applicable)
Follow the instructions below to verify the correct autopilot software is loaded.
1. Place the G900X in Configuration mode (see Section 15).
2. Use the FMS knob to select the GIA RS-232/ARINC 429 Configuration page.
3. Verify the installed autopilot is configured correctly by determining the corresponding RS-232
and ARINC 429 data listed in Table C-7.
Table C-7. G900X RS-232/ARINC 429 Autopilot Verification Table
Autopilot
CHANNEL
TruTrak
Digiflight II
Series CHNL 2
(G900X
only)
TruTrak
Sorcerer /
DFC
CHNL 2
Series
(G900X
only)
TruTrak
Digitrak /
Pictorial
CHNL 2
Pilot
(G900X
only)
Trio
Avionics
EZ Pilot CHNL 2
(G900X
only)
TruTrak
ADI
CHNL 2
(G900X
only)
S – TEC
CHNL 2
55X
4. Using the FMS knob select the GIA CAN/RS-485 Configuration page.
5. Verify the installed autopilot is configured correctly by determining the corresponding RS-485
data listed in Table C-8.
Page C-8
Revision D
RS-232
INPUT OUTPUT
AVIATION
(AVIATION 2
with software
OFF
version
006-B0718-05
only)
AVIATION
(AVIATION 2
with software
OFF
version
006-B0718-05
only)
AVIATION
(AVIATION 2
with software
OFF
version
006-B0718-05
only)
AVIATION
(AVIATION 2
with software
OFF
version
006-B0718-05
only)
AVIATION
(AVIATION 2
with software
OFF
version
006-B0718-05
only)
GIA GIA
DEBUG DEBUG
G900X/G950 Installation and Maintenance Manual – PICP & Warranty Registration
ARINC 429
CHANNEL SPEED
OUT 1 Low
OUT 1 Low
OUT 1 Low
OUT 1 Low
OUT 1 Low
OUT 1 Low
Configured
Autopilot
Software
DATA
(Check One)
GEN
PURPOSE
GEN
PURPOSE
OFF
OFF
OFF
GEN
PURPOSE
190-00719-00