ProScan PS32130 User Manual page 78

Blank screen
• Maybe the device connected to the input jacks is not turned on.
• Try another channel.
• Press RESET,in case the picture controls are set too low.
No sound, picture okay
• Maybe sound is muted. Try pressing volume up button to restore
sound.
• Maybe TV's speakers are turned off. Check Speakers On/Off function.
• If using an S-VHS component, remember to also connect the compo-
nent's I_and R AUDIO OUT jacks to the TV's L and R INPUT 1 jacks.
• Maybe SPEAKERswitch on the back of the TV is not in the
INTERNAL position.
Can't select certain channel
• If using a VCR, check to make sure the TV/VCR switch on the VCR is
in the correct position.
Noisy stereo reception
• May be a weak station. Use the Audio Processor, which is found in
the Audio Menu, to change your sound mode from stereo to mono.
No picture, no sound but power light is on
• Maybe cable/air function is in wrong position.
• Maybe a vacant channel is tuned.
• If watching VCR (connected only through antenna input), make sure
TV is tuned to channel 3 or 4 - same as CH3/4 switch on VCR. Also
check to make'sure TV/VCR switch on VCR is in correct position.
Sound_okay, picture poor
• Check antenna connections.
• Try adjusting sharpness function to improve weak signals.
Black Box appears on the screen:
• Captioning may be turned on. Check the Closed-Caption Display
control panel in the Channel Menu.
75