Programming The Remote To Control A Vcr - ProScan PS32130 User Manual

PROGRAMMING THE
UNIVERSAL REMOTE
The universal remote can be programmed to control most brands of
remote controllable TVs, VCRs, and cable boxes. Most RCA, GE and
ProScanTVs and VCRs are already programmed. Other manufacturers'
brands need to be programmed.
Programming the Universal Remote to Control a VCR
To determine whether the universal remote needs to be programmed,
turn the VCR on, point the remote at the VCR, and pressthe VCR1
button. Then press POWER or CHAN UP or DOWN to see if the
VCR respondsto the remote commands. If not, the remote needs to
be programmed.
Follow these stepsto program your universal remote to control
your VCR:
1. Turn on the VCR to be programmed.
2. Look up your VCR brand and code number(s) on the code list on
the next page.
3. Press and hold the VCR1 button on the remote.
4. Enter the two-digit code from the code list.
5. Release VCR1 then press POWER to see if the VCR responds to the
remote commands. If it doesn't, try pressing VCR1 and POWER to
see if the VCR responds.
6. Repeat tl'_se steps using the next code listed for your brand until
the VCR responds to the remote commands.
This remote may not operate all mo-
dels of the brands that are shown at
the right. Use the codes shown or on
the sheet packed in with your remote.
To program the DVDoVCR button to
control a second VCR, follow these
steps but use the DVDoVCR button
instead of the VCR I button.
For instructions on programming the
simple remote, see page 28.
24