ProScan PS32130 User Manual page 48

Normal List Only the channels included in the Normal list are
available when you scan up and down using the CHAN buttons.
Use the up and down arrows to indicate whether the channel
number indicated is included (YES) or is not included (NO) in the
Normal channel list.
Parent Approved Use the up and down arrows to choose whether
the channel indicated should be shown when the Parental Control
feature is turned on. Select YESto indicate that the channel can be
shown at any time, regardless of whether Parental Control is
turned on. Select NO to indicate that the front panel cannot tune
to that channel when Parental Control is turned on. Important:
You must turn the Parental Control feature ON in the Parental
Control control panel (see above).
Auto Channel Search Displays a control panel that lets you tell the TV
to search automatically for all the channels available through the
antenna input(s). When the TV finds an active channel, it places it in
the channel list; inactive channels (weak stations or channels with no
signal at all) will be removed from the channel list.
Auto Tuning Displays a choice list that lets you set up the TV to
automatically tune to the correct input channel when you press VCR1,
DVD.VCR, or SAT.CABLE.
Set VCR 1 Channel Displays a choice list that lets you select the
channel that the TV tunes to when you press the VCR1 button. The
choices are:
Not Connected Choose this if you do not have a VCR connected
to an anterana or Video input on the back of the TV, or if you don't
want the TV to tune to a channel when the VCRI button is pressed.
Channel 3 Antenna A Choose this if your VCR is connected to the
Antenna A jack on the back of the TV, and you want the TV to
tune to channel 3 when you press the VCRI button. Reminder:
Make sure the coml3onent's Ch 3/4 switch is set to channel 3.
Channel 4 Antenna A Choose this if your VCR is connected to the
Antenna A jack on the back of the TV, and you want the TV to
tune to channel 4 when you press the VCRI button. Reminder:
Make sure the component's Ch 3/4 switch is set to channel 4.
I utoTuning is part of the interactive 1
setup routine. For more, see Interactive
Setup, p. 15.
45