Viewingthe Picturecoming From Yourvcr - Mitsubishi HS-U780 Owner's Manual

operating yourTV withthe HS-U780 remotecontrol
O Press the TV button on the HS-U780 remote control.
O Point the remote control towards the remote sensor on the TV
and press the desired buttons.
O To once again control the VCR, press the VCR button.
Because of variations among models, some or all buttons may not
work, or they may operate different functions than expected,, for
your particular TV. If this occurs, you may need to use your TV
remote control.
_>Important:
from YourVCR
This is the most important part of using your VCR, but often the
most confusing: how do you view a picture coming from tlhe VCR?
Beforeyou begin,youshouldknow:
• whether you are viewing a "Modern _I_¢ " or an "Older TV"
(See page 21-'?.2.)
Viewing the picturecomingfrom your VCR if you are usin!;] a
modernTV
O Turn on your TV and switch it to the correct external input.
(For most Mitsubishi TVs, this means pressing the T_s
INPUT button until you see the words; "Ext-l" or "Input-1" on
the screen.)
Turn the VCR on by pressing the POWER button.
You are viewing the picture fl'om your VCR! If you wish to return
to normal TV _dewing, switch your TWs input back to its previous
position.
If you are using a modern TV, be sure to set the "RF converter" of
the "Customize choices" menu to OFF to prevent noise in the
picture. (See page 68.)
If your system includes a home theater receiver or an A/V
receiver, refer to your home theater receiver's owner's guide.
Viewingthe picture comingfrom your VCR if youare usinq an
olderTV
O Turn on your TV and tune it to channel "l or 4.
Turn on the VCR by pressing the POWER button.
O Check to see if the '_VCR" light on the f_ont panel display is
lit. If it is not lit, press the VCR]TV button until it is lit. You
are viewing the picture from your VCR! This light must be on
when you watch a video tape or use the VCR menus.
25
€ Viewingthe PictureComing
_Important:
_>Important: