Setting The Rf Converter - Mitsubishi HS-U780 Owner's Manual

Chapter 4: UsingtheAdvanced Features UsingtheAdvancedOptions (cont.)
down the number of minutes until the VCR turns off. If you want
to continue using the VCR, load a cassette or press any of the
buttons.
Setting the RF converter
_ VCR Maln?MenU _i! ! _ii_ii! i_;i_!_ ?_ii!_i
Your choices are;
_Program to record
*X01[1_=_ ,][=J. p _-4 =lE,.1,1[. IH[._I=
First Time Set-Up
If you are using an older TV without audio and video inputs, the
RF converter will need to be set to ON. The setting "RF converter"
of the "Customize choices" menu is preset by the factory to ON. If
you are using a modern TV with both audio and video inputs, you
will need to turn the RF converter OFF. To set the RF converter:
O Press the MENU button on the remote control. The '_VCR
Main Menu" appears on your TV.
Video mute (ON)
OAuto power save (OFF)
(ON)
PerfecTape (AUTO)
OA/V Network (OFF)
UseAD3UST_to
seleotili,ili_iii!ii!i!!
ana ENTER to chanse. ; :
Press MENU for Main Mehu
O
O
Use the ADJUST
dial on the remote
to sei[ect "Customize
choices". Turn the shuttle ring to the right.
The "Customize choices" menu will appear. Use the ADJUST
dial to select "RF converter." Then, turn the shuttle ring to
select ON or OFF
Press the MENU button two times to turn off the menus.
Dlmportant: If the "RF converter" is set to ON, you don't need to press the
VCR!TV button to play a tape or to use VCR menus. The "VCR"
light will automatically light up when you press PLAY or :MENU.
Usingthe ActiveAN Network
TM
Features
The Active A/V Network is a benefit of certain Mitsubishi TVs
and VCRs. The Actiw_ A/V Network allows you to use marly of the
commonly used features of your system at the press of one button.
O i iiC u S%0mize cho ices!;_i"_:
OVideo mute (ON )
OAuto power save (OFF)
ORY converter (ON )
O PerfecTape (AUTO)
(OFF)
Use ;ADJUST "co
68
Before
o
o
you begin,
your VCR must be connected to External 1 (EXT-1) or
Input-1 of a M:itsubishi TV with Actiiw; A/V Network;
(pages 15-17)
you must have turned on video mute (:page 34);
you must have turned on the Active A2¢ Network setting
on your TV (see your T_Ts owner's _aide for information);
you must have set the VCR remote mode to VCR-A; and
you must have connected a cable from the Active AFV
Network OUT terminal of the TV to the Active A/V Net.-
work IN terminal of the VCR (page 20).
To turn on the Active A/V Network on your VCR:
O Press the MENU button on the remote control. The '_CR
Main Menu" appears on your TV.
Use the ADJUST dial on the remote to select "Customize
choices." Turn the shuttle ring right.
@) The "Customize choices" menu appears on your screen. Use
the ADJUST dial to select "A/V Network."