Mitsubishi HS-U780 Owner's Manual page 18

Chapter2: Connecting YourVCR
Connectinga DSS or PRIMESTAWReceiver(optional)
18
If you have an RCA DSS, Sony DSS, or PRIMESTAR Satellite
Receiver, you can connect the receiver to your VCR. This will not
only allow you to record TV programs coming from the receiver,
but it will allow you to control the receiver with the VCR.
connecting a DSSor PRiMESTAR RECEIVER
To connect the satellite receiver, you should tLSe an S-Video cable
and one stereo audio cable to preserve the m_ximum signal
quality. You can purchase these cables at your Mitsubishi dealer
or at your local electronics store.
Top of Receiver
== Top of VCR
Front of VCR
before you begin, you should:
• have complete(] all connections between your VCR, TV, and
cable or antenna; (see pages 12-17) and
• make sure that your satellite receiver has been installed
correctly. (See your satellite receiver's manual for more
information.)
O Place the satellite receiver on top of your VCR. Align the rear
of the receiver with the rear of the VCR and align the left side
of the receiver with the left side of the VCR.
O
Connect one audio cable to the left audio output terminal ,on
the receiver; corm ect the other end of the cable to the terminal
on the rear panel of the VCR labeled AUDIO IN I_AVIONO.
Connect another audio cable to the right output terminal on
the receiver; connect the other end of this cable to the termi-
nal on the rear panel of the VCR labeled AUDIO IN R
O
Connect an S-Video cable to the S-Video output terminal on
the receiver; connect the other end of the cable to the terminal
on the rear of the VCR labeled S-VIDEO :IN. (You cannot
connect it to the terminal on the front c fthe VCR.)
BACK PANEL(VCR)
BACK PANEL (Satellite receiver)
l
l
i I
AUDIO IN IJMONO --
AUDIO IN R --
I •
t S-VIDEO IN S-VIDEO
O
/// O ._..
The plugs on the S-Video cable contain pins thaL ]
need to be aligned properly before the plugs can
J
be pushed into the terminals.
-- AUDIC) L
- --ALJDIO R
=#