Usingthe Remotecontrol To Operatethe Tv - Mitsubishi HS-U780 Owner's Manual

Chapter 3: Operating YourVCR Usingthe Remote Control(cont.)
Brand of TV Brand code
buttons
Mitsubishi 1, 2, 3
Fisher 0
G.E. CANCEL
Goldstar 2, 9
Hitachi 8
Magnavox 4
NEC 2, 9
Panasonic 6
Pioneer AUDIO
Philips 4
Proscan CANCEL
Quasar 6
RCA CANCEL
Sanyo 0
Sharp 3, 5
Sony VCR/TV
Toshiba 7
Zenith ENTER
[:>Important:
DImportant:
[::>Important:
Usingthe remotecontrol to operatethe TV
The HS-U780 remote control can operate many of the frequently-
used functions of your TV. You only need one remote to operate
both your VCR and TV.
The HS-U780 remote control is pre-set to operate Mitsubishi
televisions, but it can also operate TVs from other manufacturers.
If you need to set your remote control for your particular b:rand of
television, follow the instructions on the next page.
settingup your remotecontroltooperateyourTV
0 Turn off your TV.
O On the HS-U780 remote control, press the TV button on top of
the flip-up cover.
Flip up the (:over of the remote, then while holding in the PIP
button, press the (.'ode button listed to the left that corre-
sponds to the brand of your TV.
O Close the cover tightly, then press the POWER button. If your
TV turns on, your remote i,; set up to operate your brand of
TV.
If your TV does not turn on, repeat step _ using the next ('ode,
listed for the brand of your TV.
If none of the codes listed for the brand of your TV work, then
repeat step _ several times, using a different code button until
one works. The possible code buttons are: 0, 1.-9, CANCEL,
AUDIO, ENTER, and VCR/TV.
You do not need to perform this set-up again unless you change
the batteries, set up your remote for another brand of television,
or you get a new TV.
Once you have correctly set your remote control to operate your
TV, you will be able tc use the POWER, CHANNEL, VOLUME,
MUTE and number buttons to operate your TiT.
Depending on the model TV you have, all or some of the buttons
may not function, or they may operate different features than
indicated. You may need to use the TV's remoLe control.
Sometimes manufacturers will change the remote control codes
for their products, or they will use more than one code. If this is
the case, your remote may not be able to control your TV.
When you replace the batteries in your remote, the remote will
return to its initial setting (code button "1"). Repeat the steps
above to reset your remote control. If you enter a new code, the
previous code will be erased.
24