Top View - Maytag 23-11-2231N-004 User Manual

@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@
Ffffer P3 el I s Mf3ffo
Installing the Window Filler Panels
1. Measure distance "X" between the face of the window
stop molding and the side of the cabinet (Fig. K).
F_ K Face o[ window stop molding
Side of cabindt
Note: Measure both sides of unit separately.
2. Subtract one groove (3/16") from "X" measurement to
obtain the required width, Using a sharp knife, score
the groove until the filler panel becomes weak enough
to break apart (Fig. L).
F_o L Filh, rpanel
Slide the filler panel out from the air conditioner cabi-
net until the filler panel flange contacts the window
stop molding (position 3) (Fig. NL
4. Attach the filler panel to the face of the window stop
molding by driving upholsterers' tacks through the
holes in the filler panel flange (Fig. OL
Fills,r pane1711111111lil lll_Face of-window stop rooMing
5. Pull the sliders out until the sliders contact the face of
the window stop molding (Fig. P).
F_o _ Hole in slider Slider
"X" minus one 2¢roove(3/16")
3. Insert cut edge of the filler panel into the cabinet side
seal groove (position 1). Leave a small space at the bot-
tom of the cabinet side seal groove (Fig. M).
F_go M TOP VIEW
Face of window stop rooMing
6. Pull bottom window sash down tightly and lock it in
place by installing a 5/8" long screw through the hole
in the slider into the window sash (Fig. OL
Figo @ Slid(..
145udow stop molding€
Rotate the filler panel backward toward the window
frame until the filler panel clears the window sill. Push
the filler panel down against the window sill (position
2) (Fig. N).
F_. _
Position 3
TOP VIEW
v_
my"
5/8" long screw
7. Cut the plastic foam seal to proper length and insert it
between the upper and the lower window sash (Fig. R).
F_go R
Plastic Foam Seal
\\\
\
4