Operation - Maytag 23-11-2231N-004 User Manual

Operation°°°°°°°°°°°°°°°°°°°°°°°°°°°°°°°°°°°°°°°°°°°°°°°°°°
Power Control
E_eC_rO_fC CO_rO_ Pa_e_ Tile Power Control turns tile unit on and off.
Set Temperature/
Timer Distflay
Temperatm'e/Timer
Hour Controls
TIIllCI' Colltrol
Fan Speed
Control
Mode Control
-- Power Control
_ he heat from this unit is designed
only as a supplemental heat
source in addition to
regular heating systems.
Set Temperature/Timer Display
Shows the set temperature when the unit is in operation
and hours when the timer is being set. THE TEMPERA-
TURE DISPLAY ONLY SHOWS THE SET TEMPERATURE,
NOT THE ACTUAL ROOM TEMPERATURE.
Temperature/Timer Hour Controls
These buttons are used to raise or lower the set tempera-
ture in increments of 1 ° from 66 ° to 88 ° . By depressing
both buttons at once, the display will toggle between
Celsius and Fahrenheit. When the timer is being set, these
buttons are used to change the hour setting in increments
of 1 from 00 to 24.
Mode Control
The Mode Control has three settings: Fan, Cool,
Heat, and Energy Saver. A green light will indicate which
mode is currently being utilized.
Cool Mode - The unit will circulate and cool the air.
Fan Mode - The unit will only circulate
the air.
Heat Mode - The unit will circulate and heat the air.
Heater Safety Feature- When heater is powered off, low fan
will automatically stay on and run for 60 seconds to
ensure the removal of residual heat, meanwhile, the Low
Fan LED blinks until the low fan stops.
I=nergy Save Mode - The fan will switch from the set
fan speed to Low whenever the compressor turns off in
response to the thermostat. When the compressor cycles
back on, the unit will return to the original fan setting.
Fan Speed Control
High, Low, and Auto
The settings are adjusted with the Fan Speed Control, each
time the button is depressed it changes the setting. A
green light will indicate which setting is currently being
used.
When the Auto feature is selected while the air condition-
er is in the Cool or Heat mode, the fan speeds will change
automatically as the temperature in the room changes.
In Cool Mode when the room reaches 7 ° or more
above the set temperature High Fan will be used, 7° or
less above the set temperature will use Low fan.
In Heat Mode when the room reaches 7° or more
below the set temperature High fan will be used, 7 ° or
less below the set temperature will use Low fan.
7