Installation - Maytag 23-11-2231N-004 User Manual

Installation°°°°°°°°°°°°°°°°°°°°°°°°°°°°°°°°°°°°°°°°°°°°°°°°
Decoraffve & ChassT RemovM
Ffgo D Rernove screw fivrn both sides of cabinet Ffgo E
Cabinet Chassis
Decorative Front Removal
1. Remove the phillips screws on both sides of the cabinet
(Fig. D).
2. Remove control knobs (if unit has mechanical contols).
3. Gently pull forward while grasping both sides of the
decorative front.
Rel,17ove screw f!_om both sides of cabinet
Removing the Chassis
Remove the two (2) antitheft screws from the bottom
front side of the cabinet. RETAIN THESE SCREWS, they
will be replaced later in the installation (Fig. E).
Slide the chassis out of the cabinet by grasping the front
flange of the evaporator cover and pulling forward while
bracing the cabinet (Fig. E).
Use caution when working around exposed sharp edges
of the cabinet and sharp coils to avoid injury or torn
clothing.
Window f staffaffon (Hash Moun#
Installing Cabinet in Window
(Flush Mount)
1. Attach cabinet side seals to the existing holes in the
cabinet using the six (6) screws supplied (Fig. F).
2. Open window and mark the center of window sill.
Carefully place cabinet in window and align center
mark on the bottom tie bar with the center mark on
the window sill (Fig. F).
Slider
Cabinet
SCI'OWS
Cabinet side seal Bottom tie bar
3. Close window until it touches behind top retainer bar.
Do not close window so tightly that sliders cannot
move. (Do not release your grip on the cabinet until
the lower window sash is in its final position) (Fig. F).
4. Attach the cabinet to the window sill by driving two (2)
1" long screws through each cabinet track into the win-
dow sill (Fig. G).
Ffgo G
1" long
145mlow sill
2