Defective Its Section - Panasonic KX-F1200 Service Manual And Technical Manual

Plain paper fax with 2-line digital answering system
Hide thumbs Also See for KX-F1200:
Table of Contents

Advertisement

KX-F1200
j
9. DEFECTIVE
ITS (Integ=ated
lelephone
System) SEC[ION
9-1. NO HANDSET and SPEAKERPHONE
TRANSMISSION
/ RECEPTION
Following the ITS section (Refer to page 131 .) or NCU section (Refer to page 125.), search tor the point in the route betwe_
the handset microphone and the telephone line (sending) or between the telephone line and the handset speaker (receiving)
or between the microphone and the telephone line (sending) or between the telephone line and the speaker (receiving)
where the signal disappears, and check the components at that point.
9-2. NO PULSE DIAL
Is the voltage at
pin 97 or pin 98 of
ICl change between
high level/low level?
YES
Check pulse dial
circuit.
(Refer to page 125.)
NO
"I Remove PC2 or PC6.1
Is the voltage at
pin 97 or 98 of IC1
change between
high level/low level?
INO
YES
i Replace PC2,
I
=- R13or PC6,
R43.
=[ Check IC1.
]
9-3. NO RING TONE
Check bell detection
circuit.
(Refer to page 125.)
J
Is the bell detection
circuit OK?
I YES
Does a ring tone
signal appear at
pin 44 of IC404
(Digital Board)?
I YES
-_
Replace IC404. I
Following the ITS section
[Monitor circuit refer to page 130.],
search for the point in the route be-
tween the gate array (IC404) and
speaker where the signal disappears,
and check the components
at that point.
9-4. NO TONE DIALING
Does a DTMF signal
appear at pin 44 of
IC405 (Digital
board)?
I YES
Following the NCU section
and ITS section (Refer to
pages 125, 131.), search for
the point in the route between
the IC405 (pin 44) and
telephone jack (Tip/Ring)
where the signal disappears,
and check the components
at
that point.
---_
Replace IC405.
- 62 -

Advertisement

Table of Contents
loading

Table of Contents