Back to Contents Page
System-Board Shield
Dell™ Inspiron™ One 19 Service Manual
Removing the System-Board Shield
Replacing the System-Board Shield
WARNING:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION:
Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™
is not covered by your warranty.
CAUTION:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on your computer).
Removing the System-Board Shield
1. Follow the procedures in
Before You
2. Remove the I/O cover (see
3. Remove the computer stand (see
4. Remove the optical drive (see
5. Remove the decorative cover (see
6. Remove the speaker cover (see
7. Remove the display bezel (see
8. Remove the back cover (see
9. Remove the I/O bracket (see
10. Remove the inverter (see
Removing the
11. Remove the three screws that secure the system-board shield to the chassis.
12. Remove the system-board shield by releasing the securing clips that secure the tabs on the system-board shield.
13. Lift the system-board shield out of the chassis.
1
system-board shield
3
securing clips (2)
Replacing the System-Board Shield
Begin.
Removing the I/O
Cover).
Removing the Computer
Stand).
Removing the Optical
Drive).
Removing the Decorative
Cover).
Removing the Speaker
Cover).
Removing the Display
Bezel).
Removing the Back
Cover).
Removing the I/O
Bracket).
Inverter).
2
tabs (2)
4
screws (3)