Replacing The Mini-Card - Dell Inspiron One 19 Touch Service Manual

1 Mini-Card
Replacing the Mini-Card
CAUTION: The connectors are keyed to ensure correct insertion. Use of excessive force may damage the connectors.
CAUTION: To avoid damage to the Mini-Card, ensure that there are no cables or antenna cables under the Mini-Card.
1. Follow the procedures in Before You
2. Align the notch on the Mini-Card with the tab in the system-board connector.
3. Insert the Mini-Card at a 45-degree angle into the system-board connector.
4. Press the other end of the Mini-Card down. Replace the screw that secures the Mini-Card to the system-board connector.
5. Connect the appropriate antenna cables to the Mini-Card you are installing. The following table provides the antenna cable color scheme for the Mini-
Card supported by your computer.
Connectors on the Mini-Card
WLAN (2 antenna cables)
Main WLAN (white triangle)
Auxiliary WLAN (black triangle)
6. Replace the system-board shield (see
7. Replace the inverter (see Replacing the
8. Replace the I/O bracket (see
9. Replace the back cover (see
10. Replace the display bezel (see
11. Replace the speaker cover (see
12. Replace the decorative cover (see
13. Replace the optical drive (see
14. Replace the computer stand (see
15. Replace the I/O cover (see Replacing the I/O
CAUTION: Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may
result in damage to the computer.
16. Connect your computer and all attached devices to electrical outlets, and turn them on.
Back to Contents Page
2 screw
Begin.
Antenna Cable Color Scheme
white
black
Replacing the System-Board
Inverter).
Replacing the I/O Bracket).
Replacing the Back Cover).
Replacing the Display Bezel).
Replacing the Speaker Cover).
Replacing the Decorative Cover).
Replacing the Optical Drive).
Replacing the Computer Stand).
Cover).
Shield).