System-Board Shield; Removing The System-Board Shield - Dell Inspiron 27 7720 All-in-One Owner's Manual

Figure 22. Installing the stand hinges
Steps
1. Align the screw holes on the stand hinges with the screw holes on the display-assembly base.
2. Replace the 10 screws (M3x4.5) that secure the stand hinges to the display-assembly base.
Next steps
1. Install the I/O cover.
2. Install the back cover.
3. Install the stand.
4. Follow the procedure in

System-board shield

Removing the system-board shield

Prerequisites
1. Follow the procedure in
2. Remove the stand.
3. Remove the back cover.
4. Remove the I/O cover.
About this task
The following image indicates the location of the system-board shield and provides a visual representation of the removal
procedure.
50 Removing and installing Customer Replaceable Units (CRUs)
After working inside your
Before working inside your
computer.
computer.