Removing The I/O Bracket; Replacing The I/O Bracket - Dell Inspiron One 19 Touch Service Manual

Back to Contents Page
I/O Bracket
Dell™ Inspiron™ One 19 Service Manual
Removing the I/O Bracket
Replacing the I/O Bracket
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION: Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™
is not covered by your warranty.
CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on your computer).
Removing the I/O Bracket
1. Follow the procedures in Before You
2. Remove the I/O cover (see
3. Remove the computer stand (see
4. Remove the optical drive (see
5. Remove the decorative cover (see
6. Remove the speaker cover (see
7. Remove the display bezel (see
8. Remove the back cover (see
9. Remove the four screws that secure the I/O bracket to the chassis.
10. Without pulling hard on the I/O bracket, turn the I/O bracket to access the I/O board cable connectors.
11. Disconnect all the cables connected to the I/O board.
12. Lift the I/O bracket away from the chassis.
1 I/O bracket
Replacing the I/O Bracket
1. Follow the procedures in Before You
2. Connect all the cables connected to the I/O board.
Begin.
Removing the I/O Cover).
Removing the Computer Stand).
Removing the Optical Drive).
Removing the Decorative Cover).
Removing the Speaker Cover).
Removing the Display Bezel).
Removing the Back Cover).
2 screws (4)
Begin.