Dell Inspiron One 19 Touch Service Manual page 35

Back to Contents Page
Back Metal Shield
Dell™ Inspiron™ One 19 Service Manual
Removing the Back Metal Shield
Replacing the Back Metal Shield
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION: Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™
is not covered by your warranty.
CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on your computer).
Removing the Back Metal Shield
1. Follow the procedures in Before You
2. Remove the I/O cover (see
3. Remove the computer stand (see
4. Remove the optical drive (see
5. Remove the decorative cover (see
6. Remove the speaker cover (see
7. Remove the display bezel (see
8. Remove the back cover (see
9. Remove the I/O bracket (see
10. Remove the aluminum foil tapes from the back metal shield.
11. Remove the four screws that secure the back metal shield to the chassis.
12. Lift the back metal shield away from the chassis.
1 back metal shield
Replacing the Back Metal Shield
1. Follow the procedures in Before You
2. Align the screw holes on the back metal shield with the screw holes on the chassis. Replace the four screws that secure the back metal shield to the
Begin.
Removing the I/O Cover).
Removing the Computer Stand).
Removing the Optical Drive).
Removing the Decorative Cover).
Removing the Speaker Cover).
Removing the Display Bezel).
Removing the Back Cover).
Removing the I/O Bracket).
2 screws (4)
Begin.