3
screws (4)
Replacing the Speakers
1. Follow the procedures in
Before You
2. Route the speaker cable through the routing guides.
3. Connect the speaker cable to the connector (SPKR1) on the system board. For more information on the location of the speakers connector, see
Board
Components.
4. Replace the four screws (two on each speaker) that secure the speakers to the chassis.
5. Replace the system-board shield (see
6. Replace the inverter (see
Replacing the
7. Replace the I/O bracket (see
8. Replace the back cover (see
9. Replace the display bezel (see
10. Replace the speaker cover (see
11. Replace the decorative cover (see
12. Replace the optical drive (see
13. Replace the computer stand (see
14. Replace the I/O cover (see
Replacing the I/O
CAUTION:
Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may
result in damage to the computer.
15. Connect your computer and all attached devices to electrical outlets, and turn them on.
Back to Contents Page
Begin.
Replacing the System-Board
Inverter).
Replacing the I/O
Bracket).
Replacing the Back
Cover).
Replacing the Display
Bezel).
Replacing the Speaker
Cover).
Replacing the Decorative
Cover).
Replacing the Optical
Drive).
Replacing the Computer
Stand).
Cover).
Shield).
System