Secure The Drain Hose; Complete Installation - Maytag MHWE300VW00 Use & Care Manual

1.
2.
..................... _ _, .,,._,' ._
Drape the power cord over the washer top.
Secure the drain hose to the laundry tub leg or standpipe with the beaded strap provided.
(See illustrations A and B).
A B C
If the washer faucets and the drain standpipe are recessed (see illustration C), put the
hooked end of the drain hose in the standpipe. Tightly wrap the beaded strap around the
water inlet hoses and the drain hose.
Do not force excess drain hose into the standpipe.
Properly leveling your washer avoids excessive noise and vibration.
1. Check the levelness of the washer by placing a level on the top edge of the washe_; first
side to side, then front to back.
2.
3.
4.
5.
6.
If the washer is against a wall, move the washer out slightly before tipping back. If the
washer is not [eve[, first prop the front with a wood block and adjust the feet as necessary;
then prop the back and adjust feet as necessary. Repeat this step until washer is [eve[.
Make sure all four feet are stable and resting on the floor. Then check that the appliance is
perfectly [eve[ (use a [eve[).
After the washer is [eve[, use a 1 7 mm open-end wrench to turn the nuts on the feet tightly
against the washer cabinet.
IMPORTANT: All four feet must be tightened. If the nuts are not tight against the washer
cabinet, the washer may vibrate.
The washer should not move front to back, side to side, or diagonally when pushed on its
top edges.
Slide the washer to its final location.
Confirm the levelness of the washer.
1. Check the electrical requirements. Be sure that you have the correct electrical supply and
the recommended grounding method. See "Electrical Requirements."
2. Check that all parts are now installed. If there is an extra part, go back through the steps to
see which step was skipped.
3. Check that you have all of your tools.
4. Dispose of/recycle all packaging materials.
5. Check that the water faucets are on.
6. Check for leaks around faucets and inlet hoses.
7.
8.
9.
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
Plug into a grounded 3 prong outlet.
Read "Washer Use."
To test and clean your washer, make sure there are no clothes in the washer and add one
AFFRESH r,, tablet to the washer drum. Select POWER/CANCEl_, the Clean Washer cycle,
and then select START/PAUSE. This cycle will take approximately 50 minutes to
complete. Allow the washer to complete the entire Clean Washer Cycle without
interruption.
;Z!III
Z'I