Changing Cycles, Optoins, And Modifiers; Status Indicator; To Add Items; Cycle Done - Maytag MHWE300VW00 Use & Care Manual

v od fe s
Not all Options and Modifiers are available with all cycles. Cycles, Options, and Modifiers
can be changed anytime before START/PAUSE is selected.
Options and Modifiers can be changed anytime after START/PAUSE is selected and before
the start of the selected Option or Modifier.
To cancel a cycle and begin a new cycle
1. Select POWER/CANCEl. twice.
2. Select desired cycle.
3. Select the desired OPTIONS.
4. Select START/PAUSE (for approximately 1 second) to restart the washer at the beginning
of the new cycle.
To cancel a cycle
1. Select POWER/CANCEl once.
2. The washer powers down, the door unlocks, and clothes can be removed.
NOTE: If the water [eve[ or the temperature is too high, the washer will drain automatically
before the door unlocks.
To change Options or Modifiers after the cycle has started
1. Select START/PAUSE once.
2. Select the desired OPTIONS or MODIFIERS.
3. Select START/PAUSE (for approximately 1 second) to continue the cycle.
To drain the washer manually
1. Select START/PAUSE once.
2. Select DRAIN/SPIN.
3. Select START/PAUSE (for approximately 1 second) to begin the drain.
4. When the spin is complete, the door unlocks. Items can be removed from the washer.
This indicator shows which portion of the cycle the washer is operating and the estimated
time remaining. It also indicates when you can add an additional item to the wash cycle
and when the controls are locked.
estimated time remaining
sensing estimated time
delay add wash rinse spin done
clothes
To add items
1. Select START/PAUSE once. The washer door unlocks, and items can be added.
2. To continue the cycle, dose the door and select START/PAUSE (for approximately
1 second).
3. To unlock the door after the Add Clothes period, press POWER/CANCEl twice.
This will cancel the Wash Cycle.
Cycle done
The cycle done indicator stays on for 60 minutes, until the door of the washer is opened,
or the Power/Cancel button is pressed.
Locking controls
The Control I_ock avoids unintended use of the washer. You can also use the control lock
feature to avoid unintended cycle or option changes during a cycle. When Control lock light
is [it during a cycle, all buttons are disabled except for the Control lock, Power/Cancel, and
Start/Pause buttons.
To lock the controls
Select and hold CONTROl lOCK button for 3 seconds.
Q
control lock
hold 3 seconds
The CONTROl_ I_OCK status light illuminates.
To unlock the controls
Select and hold CONTROl lOCK for 3 seconds until the Control lock status light turns off.
Door Locked
When the status light illuminates, the door is locked.
Estimated time remaining
The cycle time varies automatically based on your water pressure, water temperature,
detergent, and clothes load. The cycle time will be extended if oversudsing occurs or the load
is unbalanced. The SUDs routine removes extra suds and assures proper rinsing of your
clothes. During the unbalance routine, the time displayed may pause until this activity is
complete, then resume with the cycle. These routines may add up to a half-hour to the default
cycle time.
Adding items
This washer allows an 8-minute period in which other garments may be added to the load.
You can add items to the washer if the status indicator shows Add Clothes.
16