Drain System; Electrical Requirements; Laundry Tub Drain System; Floor Drain System - Maytag MHWE300VW00 Use & Care Manual

Recommended installation spacing for cabinet installation
• The dimensions shown are for the recommended spacing.
• For cabinet installation, with a doo_, the minimum ventilation openings in the top are
required.
7"(17.8 cm)
11
-'_(922.9 cm)
The washer can be installed using the standpipe drain system (floor or wall), the laundry tub
drain system, or the floor drain system. Select the drain hose installation method you need.
See "Tools and Parts."
Standpipe drain system - wall or floor (views A & B)
The standpipe drain requires a minimum diameter standpipe of 2" 15 cm). The minimum
carry-away capacity can be no less than 17 gal. (64 I_) per minute.
The top of the standpipe must be at least 30" (76.2 cm) high and no higher than 96" (2.4 m)
from the bottom of the washer.
30" rnin.
(76.2 cm)
L
Laundry tub drain system (view C)
The laundry tub needs a minimum 20 gal. 176 I.) capacity. The top of the laundry tub must be
at least 30" (76.2 cm) above the floor.
Floor drain system (view D)
The floor drain system requires a siphon break that may be purchased separately. See "Tools
and Parts."
The siphon break must be a minimum of 28" (71 cm) from the bottom of the washer.
Additional hoses might be needed.
C
(71 ?_
D
Eiectrica[ Shock Hazard
Plug into a grounded 3 prong out[et.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
A 120 volt, 60 Hz., AC only, 15- or 20-amp, fused electrical supply is required. Time-
delay fuse or circuit breaker is recommended. It is recommended that a separate circuit
serving only this appliance be provided.
B