Secure The Drain Hose - Maytag AUTOMATIC WASHER Use & Care Manual

Clear the water lines
Run water through both faucets and inlet hoses, into a laundry tub, drainpipe or bucket,
I
to get rid of particles in the water lines that might clog the inlet valve screens.
Check the temperature of the water to make sure that the hot water hose is connected to
I
the hot water faucet and that the cold water hose is connected to the cold water faucet.
Connect the inlet hoses to the washer
A
B
A. Cold water inlet valve
B. Hot water inlet valve
1. Attach the hot water hose to the bottom inlet valve.
2. Attaching the hot water coupling first makes it easier to tighten connection with pliers.
3. Screw on coupling by hand until it is seated on the washer.
10
4. Using pliers, tighten the couplings with an additional two-thirds turn.
NOTE: Do not overtighten or use tape or sealants on the valve. Damage to the valves can
result.
5. Attach the cold water hose to the top inlet valve.
6. Screw on coupling by hand until it is seated on the washer.
7. Using pliers, tighten the couplings with an additional two-thirds turn.
NOTE: Do not overtighten or use tape or sealants on the valve. Damage to the valves can
result.
Check for leaks
Turn on the water faucets and check for leaks. A small amount of water might enter the
washer. You will drain this later.
NOTE: Replace inlet hoses after 5 years of use to reduce the risk of hose failure. Record hose
installation or replacement dates for future reference.
If you connect only one water hose, you must cap off the remaining water inlet port.
I
Periodically inspect and replace hoses if bulges, kinks, cuts, wear, or leaks are found.
I

SECURE THE DRAIN HOSE

1. Remove the shipping material from the power cord. Drape the power cord over the
console.
2. Remove any cardboard used to move washer.
Beaded tie strap