NEC Storage Manager Reference page 74

Separate Normal End
MV:/dev/rdsk/c0t1d0
RV:/dev/rdsk/c0t2d0
#
[ NOTES ]
• The MV and RV to be operated must be recognized as replication target disks by Replication
Control.
• The MV and RV to be operated must be set as a pair.
The following notes apply to the case when joint operation with the replication management is not
performed (the I/O issuance to disk arrays is directly controlled via FC).
• The MV or RV to be operated must be registered in the Volume List.
• A volume of a dynamic disk cannot be specified.
• The MV or RV to be operated must be of a disk array under control of the local host.
• If only RVs are specified, RV must be of a disk array under control of the local host.
• A Volume List must not be being created.
When specifying the combination of a volume group or a disk group with a special file name
(logical disk name), for an MV(RV), specify the same number of logical volumes that constitute
a volume group or a disk group on the specified special file name (logical disk name) side.
To specify a volume group, the target volume group must be active.
To specify a disk group, the target disk group must be active.
The iSM special file is not being created (the UNIX system HP-UX version only).
[ RETURN VALUE ]
0: Operation for all the paired volumes terminated normally.
If the state specified for the wait end condition is already placed, normal termination is
assumed.
1: Operation for all the paired volumes terminated abnormally.
2: Operation for some paired volumes terminated abnormally.
[ ERRORS ]
The wait command terminates abnormally in the following cases:
• A parameter is invalid.
• The instruction fails due to a disk array error.
• The state specified for the wait end condition is not placed before the specified time limit.
Chapter 2 Command Reference
2000/10/10 09:11:24
disk001
disk002
69
NX
NX