The Oven Light - Kenmore SELECT CLEAN 665.75827 Use & Care Manual

REMOVING THE OVEN DOOR (contd.)
2. Hold oven door so that the top edge of each Door stop Range
hinge hanger is horizontal insert hinge hangers clip ..............
into the front frame hinge slots. Hinge
3. Tilt top of door toward range. Slide hinge Door removal _ ......... hanger
hangers down onto front frame support pins. pinhole
,_ _:_
.o.o: ake sure ,oge hangers are fu,ly !!; ,n°
seated and engaged on the support pins. ...... "
4. Insert the door stop clip with the angular surface
at the top of the frame hinge slot, then push in
the bottom of the clip until flanges are flush with Fr a
the front frame, hinge slot
5. Open the door completely and remove the door
userem°val .... pins. Save door removal pins for future I[ [ Angular
....... surface of
6. Close the door, door stop
7. Check for alignment to make sure door is Door removal clip
installed evenly, pin hole \ |
THE OVEN LIGHT
The oven light will come on when you open the
oven door. The oven light will not work during the
Self-Cleaning cycle.
_s tsm t58 l_gh_, 0s 0r'off _*_her_ the 0yes
800ris ct0s÷a: ,,,,o
a Press the OVEN pad.
Toreptace th÷ _e_ _i_ht:
1. Unplug range or disconnect power.
2. Remove the glass bulb cover in the back of the
oven by turning it
counterclockwise.
4.
Replace the light bulb cover by turning it clockwise.
F
3. Remove the light bulb from its socket by turning 5. Plug in range or reconnect power.
it counterclockwise. Replace the bulb with a
40-watt appliance bulb.
35