The Oven Light - Kenmore SELECT CLEAN 665.75822 Use & Care Manual

REMOVING THE OVEN DOOR (contd.)
2.
Hold oven door so that the top edge of each
hinge hanger is horizontal. Insert hinge hangers
into the front frame hinge slots.
3.
Tilt top of door toward range. Slide hinge
hangers down onto front frame support pins.
NOTE: Make sure the hinge hangers are fully
seated and engaged on the support pins.
4.
Insert the door stop clip with the angular surface
at the top of the frame hinge slot, then push in
the bottom of the clip until flanges are flush with
the front frame.
5.
Open the door completely and remove the door
removal pins. Save door removal pins for future
use.
6.
Close the door.
7.
Check for alignment to make sure door is
installed evenly.

THE OVEN LIGHT

The oven light will come on when you open the
oven door. The oven light will not work during the
Self-Cleaning cycle.
To turn the light on or off when the oven
door is closed:
•
Press the OVEN pad.
To replace the oven light:
1.
Unplug range or disconnect power.
2.
Remove the glass bulb cover in the back of the
3.
Remove the light bulb from its socket by turning
it counterclockwise. Replace the bulb with a
40-watt appliance bulb.
oven by turning it
counterclockwise.
CARING FOR YOUR RANGE
Door stop
clip
Door removal
pin hole
Door removal
pin hole
4.
Replace the light bulb cover by turning it clockwise.
5.
Plug in range or reconnect power.
Range
Hinge
hanger
Support pins
Front frame
hinge slot
Angular
surface of
door stop
clip
35