How The Cycle Works; Setting The Controls - Kenmore SELECT CLEAN 665.75827 Use & Care Manual

HOW THE CYCLE WORKS
The SELECT CLEAN
TM
Self-Cleaning cycle uses
temperatures much hotter than normal oven use to
break up and burn away soil and grease. SELECT
CLEAN will set the clean time automatically, once
you choose the soil level. You can choose SoilL
(light soil), SoilA (average soil) or SoilH (heavy soil).
SoilL will clean for approximately 2-2½ hours, SoilA
for 3-3_ hours and SoilH for 4-41/2hours.
The door must be closed completely for it to lock and
the cycle to begin. If properly closed, the door will
lock approximately 6 seconds after START/ENTER is
pressed. The cycle time includes an approximate 30
minute cool down time. To see the time of day during
the cycle, press CLOCK for 5 seconds.
SETTING THE CONTROLS
.......,,,,,, ...... ....
1. Press SELECT CLEAN.
Press pad twice, SoilA (for average soil) will
replace SoilL.
Press pad three times, SoilH (for heavy soil) will
replace SoilA.
NOTE: You can scroll through all 3 settings
(SoilL, SoilA and SoilH) continuously by pressing
SELECT CLEAN.
PRESS YOU SEE
(example shows light soil
setting)
2. Press START/ENTER. PRESS YOU SEE
START
ENTER
3, After the SELECT CLEAN Self-Cleaning cycle ends: YOU SEE
LOCKED goes off and the door unlocks.
4. Press any pad or open the door to remove "End" YOU SEE
and bring back time of day.
5. After the oven is cool, wipe off any residue or ash
with a damp cloth or sponge.
If needed, touch up spots
with a mild abrasive cleanser
or cleaning sponge.
continued on next page 27