Healthrider C895e User Manual page 8

7. Applya small a mount o ftheincluded Teflon ® lubricant
toa papertowel.Ruba thinfilmofthelubricant o nto
eachUpper B odyLeg(31).
Identify the LeftUpper Body Arm(112), w hichis
marked withan"L"sticker.Slidethe LeftUpper B ody
ArmontotheleftUpper BodyLeg(31).Slidethe Right
Upper Body Arm(118)ontotherightUpper BodyLeg
(notshown).
M ake sure that the Upper Body Arms
are on the correct sides. Next, slide an Axle Cover
(26) onto the post on each Upper Body Arm.
Apply grease to the Arm Axle (19). Insert the Arm Axle
into the Upright (2), the right Axle Cover (26), and the
Right Upper Body Arm (118). Next, push the Arm Axle
into the Upright until the left end of the Arm Axle is
flush with the left side of the Upright. Then, raise
the Left Upper Body Arm (112), and insert the Arm
Axle into the left Axle Cover (26) and the Left Upper
Body Arm. Center the Arm Axle and rotate it so the
indicated hole is in the position shown.
8. Have another person hold the Left Handlebar (24)
near the Upright (2) as shown. Connect the left Pulse
Sensor Wire (20) to the Pulse Extension Wire (101 ).
Slide an Axle Cover Endcap (91) onto the lower end of
the Left Handlebar.
Slide the upper end of the Left Handlebar (24) into the
tube on the front of the Upright (2), while sliding the
lower end of the Left Handlebar onto the Arm Axle
(19). Attach the upper end of the Left Handlebar with
two M8 x 42mm Button Bolts (85) and two M8 Nylon
Jam Nuts (86); be careful not to damage the Wires
(20, 101) as you insert the Button Bolts. Make sure
that the Jam Nuts are resting in the hexagonal
holes in the tube on the front of the Upright. Attach
the lower end of the Left Handlebar with an M8 x
35mm Button Bolt (105) and an M8 Jam Nut (86).
Press the tabs on the Axle Cover Endcap (91) into the
left Axle Cover (26).
Attach the Right Handlebar (23) to the Upright (2) in
the same way.
Hold the halves of the Handlebar Cover (25) around
the tube on the front of the Upright (2); be careful not
to damage the Wires (20, 101}. Attach the Handlebar
Cover with an M4 x 16mm Round Head Screw (96).
\\
\\
\
26
Hole
2
// //
24
23
86
91